Vert-Skating-Forum, Message 1197

RollerSkater Dave: Kingpin for Indy Truck 101 (7. Apr. 2004 04:04)

If hunting through skate shops yields no results, you could go to a hardware store and get some grade 8 bolts of the right diameter and length (you could cut them down if they're a little long). For the head of the bolt you'll have to grind off just a little bit on two opposing sides of the hex so they'll drop down into the slot. Buy matching nuts for the new bolts because your old ones will have a different thread.

RS Dave

Write reply

Sender:	Daniel
email:	knopf@chem.ubc.ca
Subject:	Kingpin for Indy Truck 101
Content:	Hi, during some of the last sessions with Lisa (www.rollergirl.ca) in Vanocuver I twistet the kingpins on two of my Indy 101 trucks. Does anybody know where a can get some spare ones? Thanks and regards from Vancouver, Daniel
	Write reply

Vert-Skating-Forum

Message 1197 (6. Apr. 2004 04:09) (Tree)

Replies

Daniel: Kingpin for Indy Truck 101 (6. Apr. 2004 04:09)
	Hi, during some of the last sessions with Lisa (www.rollergirl.ca) in Vanocuver I twistet the kingpins on two of my Indy 101 trucks. Does anybody know where a can get some spare ones? Thanks and regards from Vancouver, Daniel
	Write reply

Bernhard: Kingpin for Indy Truck 101 (6. Apr. 2004 22:31)
	: during some of the last sessions with Lisa (www.rollergirl.ca) in Vanocuver I twistet the kingpins on two of my Indy 101 trucks. It seems that you not only twisted your kingpins but that you also twisted Vancouver. ;-) : Does anybody know where a can get some spare ones? At the friendly skate shop round the corner?
	Write reply

Daniel Knopf: Kingpin for Indy Truck 101 (7. Apr. 2004 00:42)
	: Hi Bernhard, : : I will definitely check the Skateshop around the corner, but I was wondering about the sizes/length of the Kingpins. I had two Indy 101 trucks which Kingpins differed significantly. I hope that I can use a Kingpin of a newer model. I bet Chirs Eggers will know definitely which newer Indy Truck has the same Kingpin size than my old ones. : : Regards, Daniel
	Write reply

irene: Kingpin for Indy Truck 101 (7. Apr. 2004 03:02)
	Greetings Daniel, Most of the new kingpins I've come across have been too short. Indy does carry new 101s, but that would be an expensive way to replace kingpins. I don't know of any sources for old longer kingpins. Good luck hunting!
	Write reply

Daniel: Kingpin for Indy Truck 101 (7. Apr. 2004 05:40)
	Hi Irene, hi Dave, thanks for the hints. If I won't find some "old stuff" in some skateshops I will try to use a "normal" screw with corresponding nut. Shouldn't be a big deal to cut it down. Regards, Daniel
	Write reply

Chris Eggers: Kingpin for Indy Truck 101 (14. Apr. 2004 13:50)
	I bet Chirs Eggers will know definitely which newer Indy Truck has the same Kingpin size than my old ones. : : Uh not really..........you don´t break kingpins slaloming actually....if you are not too heavy. The hardware store is a good idea I am sure....if not check Daddies boardshop online resource, they might know...
	Write reply