Vertical Rollerskating

Vert-Skating-Forum

Message 8921 (16. Apr. 2009 21:31) (Tree)

Replies

claudine: Project 2/stickers (16. Apr. 2009 17:29)
	Here is the front end of my bike with close up of sticker. Front ends done! Its glossy sticker paper. Its thin so I put some clear packing tape on top so it doesnt rip or smear. I hand cut them, not exact but I have a good hand. I would laminate them instead but I am keeping costs down and a little ridge in the tape wont make or break me. The paper isnt cheap. Its $2/sheet so I didnt print them til I was sure. For the uni I might want to redesign the RG stickers but its not my design so dont think I should. : : Wow! How easy is it for you to do those stickers? I'm almost out of Sk8Mag.de stickers and I only got an offer from a local guy some years ago which is just too expensive. I should look up a sticker service on the net.
Image:
	Write reply

claudine: Project 1 :-D (17. Apr. 2009 05:04)
	: : : I redesigned my uni so the kids wouldn't mistake me for either a guy or girl. : : : : What are you if you are not a guy or a girl? : : Eunuch? Hermaphrodite? : : Or (beware!) a roller skater? lol, no I'm supergir!! :-D Dont they know a super hero when they see one? ;-D So today I was riding up and down the steep hill here, kids chasing after me. And today one asked if I were a cop lol???????? Like a cop could do something on a unicycle? lol. Or am I looking big and bad nowadays lol? But Doc said arm is fine. I'm going to the bowls tomorrow or Sat. I might join the Olney skatepark. Its 7 miles away, has a good street concrete section with corners to carve. All the bowls are an hour away and my car is on limited miles so I can rarely go now. Thats a lot better then the asphalt one here with just 1/4 pipes to launch onto boxes and no corners to carve.
	Write reply

Go to the Vert-Skating-forum