Vertical Rollerskating
Vert-Skating-Forum
Message 5438 (5. Apr. 2008 06:53) (
All
next
previous
)
Sender:
claudine (
videos by claudine
) (
pictures by claudine
)
Subject:
its cut but...
Content:
Pretty easy to cut actually, but the edges are sharp. Sand/dremel/file? Hints or I will just figure it out lol.....
Write reply
Replies
claudine:
cutting aluminum? (5. Apr. 2008 01:13)
claudine:
its cut but... (5. Apr. 2008 06:53)
ludi:
its cut but... (5. Apr. 2008 13:31)
claudine:
its cut but... (5. Apr. 2008 15:24)
Bernhard:
its cut but... (5. Apr. 2008 18:43)
claudine:
its cut but... (5. Apr. 2008 20:29)
Robert:
its cut but... (5. Apr. 2008 16:53)
Bernhard:
its cut but... (5. Apr. 2008 20:06)
claudine:
its cut but... (5. Apr. 2008 20:20)
Bernhard:
its cut but... (5. Apr. 2008 22:35)
claudine:
its cut but... (7. Apr. 2008 13:06)
Bernhard:
its cut but... (5. Apr. 2008 14:49)
h ludi:
its cut but... (7. Apr. 2008 13:17)
claudine:
its cut but... (8. Apr. 2008 02:28)
h. ludi:
its cut but... (11. Apr. 2008 13:42)
Bernhard:
its cut but... (11. Apr. 2008 14:03)
Bernhard:
its cut but... (7. Apr. 2008 13:40)
Go to the Vert-Skating-forum