| Ok, I have finally decided to make slider and have reviewed all of the awesome diagrams. I see that most of the setups have a diagnol cut where the trucks are. I keep my trucks very very loose and am concerned they will rub on the slider. I am anxious to get this done so any suggestions and pictures of the bottom of your skates would be very helpful. I did re read the thread from March and the diagrams were awesome, but that part of my plate is not flat and slopes down. I am going to see about having a plastic fabrication shop do it for me, but am still open to trying it myself. I don't understand how you screw the slider into the plate? Also, can you thread the hole so that you can replace the slider?
Thanks,
Rob
|